Wasp-bar-code WPA206 User Manual download pdf

5. Connect the USB Cable / Cradle

and Charge the Main Battery

Connect the USB connector to an

available USB port on the back of your

PC.

The cable on the power supply connects

to the rear of the USB connector or cradle.

Plug one end of the power cable into the

black power supply box. Plug the other

end of the power cable into an AC outlet.

Plug the other end of the USB cable into

the bottom of the WPA206 unit. It will only

fit into the slot one way. If it does not go in

easily, turn the cable over and try again.

After connecting all the cables, the unit will

begin charging. The battery is charged

when the red LED on the top front of the

unit turns green. You may use the unit

while plugged in but charge the unit for at

least 16 hours before mobile use.

(The LED on the power supply is always

green when powered.)

6. Power on the WPA206

Press the power key to turn on the

WPA206. (To turn the unit off, press and

hold the power key for about one second.)

After powering on the unit, follow the

WPA206 onscreen prompts to set up the

unit and set the time zone. The correct

time zone is very important. Based on the

time zone you set, the date and time will

be synced with the PC each time the unit

is connected and synced.

7. Install ActiveSync software

Using the included Microsoft ActiveSync

CD, install ActiveSync. Follow the

onscreen prompts in the installer.

If you purchased any integrated Wasp

software, you should install that software

after ActiveSync is installed.

8. Other Accessories and Parts

Other accessories and parts that come with

this unit include an extra stylus, PCMCIA

pull tape, and a CF card holder.

The PCMCIA slot is in the top compartment

on the back of the unit. Before inserting a

PCMCIA card, attach a strip of the pull tape

to the end of the card so that it will stick out

of the slot. This will allow you to remove the

card by pulling the tape.

The CF card slot is in the battery

compartment. The battery and a small snap

on cover behind the battery must be

removed to access the slot. Attach the CF

card to the supplied holder and slide it into

the memory slot. The holder will allow you

to properly install and remove the card.

WPA206

Quick Start

Guide

1 2

Summary of Contents

Page 1 - Quick Start

5. Connect the USB Cable / Cradle and Charge the Main Battery Connect the USB connector to an available USB port on the back of your PC. The cabl

Page 2 - Steps for getting started

Steps for getting started with your WPA206 mobile device 1. Unpack Open the box and remove all the pieces from their protective packaging. Parts incl

Comments to this Manuals

No comments

Wasp-bar-code WPA206 User Manual

Browse online or download User Manual for PDAs Wasp-bar-code WPA206. Wasp Bar Code WPA206 User Manual

Summary of Contents

Comments to this Manuals